Remote Control Is Not Operable

<p>[TOC]</p> <h3>I. Problem Phenomenon</h3> <p>The device cannot be operated by pressing the remote control.</p> <h3>II. Analysis steps</h3> <p>Follow the steps below to investigate the causes of the problem one by one:</p> <p>1、The remote control is not loaded with batteries, or the batteries are low. 2、Damage to the remote control. 3、Equipment infrared receiver, the hole position is obscured. 4、Not facing the device infrared receiver operation. 5、Failure of the infrared function of the device. 6、Equipment anomalies, inoperable anymore.</p> <h3>III. Operating instructions</h3> <h4>1、The remote control is not loaded with batteries, or the batteries are low</h4> <ul> <li>Change a new battery, such as still can not operate, and then further investigation.</li> </ul> <h4>2、Damage to the remote control</h4> <ul> <li>Change a new remote control to operate the device again.</li> </ul> <h4>3、Infrared receiver or hole position of the device is blocked</h4> <ul> <li>The infrared receiver of the device is usually directly in front of the device and you need to make sure that the front of the device cannot be blocked by anything else.</li> </ul> <h4>4、Face-to-face operation of equipment</h4> <ul> <li>The infrared receiver of the device is usually in front of the device, it needs to be operated right in front of the device and cannot deviate from the direction, which will lead to inoperability.</li> </ul> <h4>5、Failure of the infrared function of the device</h4> <ul> <li>The first few hardware problems have been eliminated, but still can not operate the device, you can contact the manufacturer to confirm and repair the device infrared function.；</li> </ul> <h4>6、Equipment abnormalities</h4> <ul> <li>Equipment abnormal, dead phenomenon, the remote control will also be unable to operate the device, you need to power off the device, and then power up and restart.</li> </ul>